Double Shower Curtain Rod Installation Instructions

Rotate the wall plate until it fits flush with the end of the rod.

Double shower curtain rod installation instructions.

7 slide the 2nd wall plate into the rod as shown below see figure d. X pilot hole anchor. Thread the shower curtain hooks rings through the curtain and liner. In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home.

Then install the rod and place a level across the length of the rod. For rods 84 and longer assemble with the connector piece. Once level have an assistant mark where the rod intersects the other wall. Spring loaded or spring tension shower curtain rods are a quick solution to getting your shower splash under control or brushing up a less than.

Using the hardware that is incl. Install the first bracket by screwing it into place. It may use spring loaded clips that fit into holes in the bracket or screws that secure the rod to the bracket. Starting from the left side thread one ring through the holes of both the curtain and the liner.

Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1. 6 with the fronts of the 2 covers facing together slide the covers onto the rod see figure c. How to install spring loaded shower curtain rods. If there is a stud in your mounting location use wood screws to attach the wall brackets.

Lay the rod sections on the floor. Gently tap the anchors into the pilot holes with a hammer. Drill pilot holes for the wall anchors. Place the wall brackets onto the ends of the shower rod and tighten the set screws secure.

Install your brackets using these marks for a level rod. Attach the rod and brackets to the wall with the mounting hardware provided. Continue threading until all 12 rings have been threaded through all 12 holes. If not trim with a hacksaw.

Hold it while you level the rod. The method may vary by manufacturer. Straight double shower curtain rod installation 5. Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall.

Once you find the proper height level the shower rod.